Suitable for higher engine speeds and heavier loads. These bearings are composed of 3 different sliding bearing materials, for the highest possible resistance to high power and high speeds. Available in standard sizes (most cars) and 0.25 mm oversize versions.
Mathijssen Technics Performance Bearings Feature:
Full grooved to maximize oil flow to the rod bearing. Both rods & mains have a high crush for max retention and reduced overlay thickness to prevent fatigue. Rod bearings use hardened steel backs for added strength.
These bearings should be used wherever high RPM's (above 6000), nitrous, superchargers, turbochargers or any application where above normal HP & RPM's are made.
All motors benefit from these strenghtened bearings. These bearings will give longer life to any engine by increasing oil to the pins & eliminating oil starvation.
Bearings are Tri-metal cast copper lead with copper lead lining to withstand engine loads, along with electroplating babbitted overlay providing optimum service.
All bearings are available in Standard, and 0,25mm over sizes.